Fanless and silent
Completely fanless, virtually noiseless
Passive cooling through convective heat transfer
Perfect to be used in noise-sensitive environments
Fanless means less dust and thus virtually no maintenance is required
24/7 Nonstop Operation
This device is approved for 24/7 permanent operation.
Requirements:
- Free air circulation around the PC must be guaranteed.
- Ventilation holes must be kept clear.
- Any installed disk must also be approved for permanent operation by its manufacturer
Chassis
Slim PC with black chassis made of steel
Dimensions: 190 × 165 × 43 mm (LWH) = 1.35-litre
Weight: 0.8 kg net and 1.95 kg gross
Two holes for Kensington Lock and numerous
threaded holes (M3) at both sides of the chassis
Operation Position
1) Horizontal
2) Vertical with mounted feet.
These feet can be purchased as optional accessory PS02.
3) Vertical (e.g. VESA-mounted behind an appropriate monitor)
In the vertical position, the front USB ports should point upward.
Ventilation holes must not be blocked to ensure sufficient cooling.
Operation System
This system comes without an operating system.
It is compatible with
- Windows 10 (64-bit)
- Windows 11 (64-bit)
- Linux (64-bit)
Processor
Intel® Pentium® Silver Processor N6005, Quad-Core
CPU clock frequency: 2.0 GHz, max. Turbo frequency: 3.3 GHz
Code name: "Jasper Lake"
10 nm structure, FCBGA1338 package (soldered)
CPU cores / Threads: 4 / 4
L2 Cache: 4 MB
Thermal Design Power (TDP): 10 W
Supports x86-64, AES-NI, VT-x (EPT), VT-d, SSE4.2, AES
System-on-Chip processor (SoC) with integrated graphics processor, no chipset required
Integrated Graphics
The Graphics Processing Unit (GPU) is integrated into the processor
Intel® UHD Graphics (11th Gen), GPU frequency: 450~900 MHz
Supports DirectX 12, OpenGL 4.5, OpenCL 1.2, Intel Quick Sync Video, Intel Clear Video (HD)
Execution Units (EU): 32
Triple Display Support via three video outputs:
- HDMI 2.0b: max. 4096 × 2160 @ 60 Hz
- DisplayPort 1.4a: max. 4096 × 2160 @ 60 Hz
- D-Sub/VGA: max. 1920 × 1200 resolution @ 60 Hz
Supports two digital displays and one analog display simultaneously.
The D-Sub/VGA connector does not support the Hot Plug feature.
UEFI Firmware
16 MB Flash ROM with AMI's Aptio UEFI BIOS Firmware
Based on the Unified Extensible Firmware Interface (UEFI)
Supports Power fail resume / AC power on state / always-on / always-off
Supports Wake-on-LAN (WOL) from S3, S4, S5 ACPI states
Supports boot up from external flash memory cards
With embedded Firmware TPM v2.0 (fTPM)
CMOS battery (type CR2032)
Memory Support
2× SO-DIMM slots with 260 pins
Supports DDR4-2933 (PC4-23466U) SDRAM at 1.2V
Supports Dual Channel mode
Supports max. 16 GB per DIMM
Maximum total size: 16 GB (either 1× 16 GB or 2× 8 GB)
Supports two unbuffered DIMM modules (no ECC)
2.5" Bay for Hard disk drive/SSD
Supports one drive in 6.35 cm / 2.5" format (hard disk or SSD)
Serial ATA III Interface with up to 600 MB/s transfer speed
Max. height 12.5 mm
Pre-installed SATA cable (data/power)
Supports Unified Extensible Firmware Interface (UEFI)
M.2 expansion slot for SSD card
M.2-2280 BM slot
Interfaces: PCI-Express Gen. 3.0 X2 and SATA v3.0 (max. 6 Gbit/s)
Supports M.2 cards with a width of 22 mm
and a length of 42, 60 or 80 mm (type 2242, 2260, 2280)
Supports SATA SSDs (BM-Key) or NVMe PCIe SSDs (M-Key)