Cooling

As computers generate more and more heat, cooling has become and important part. So a good case should provide enough cooling possibilities.
In this case you can place a maximum of 5 fans, without any modding off course.
In the front panel there’s room for 2x 80 mm fans. Installation of these is very simple as you only have to click them in. To avoid that your case will fill up with dust in no time, there’s a dust filter installed. Isn’t that easy?
These fans will also cool your hard drive(s) as they are situated right in front.


2*80 mm front fan holder + dust filter:




The hot air has to get out of your case. That’s logical. To do that SuperFlower included an 80 mm fan installed in the top panel. It does not support rpm monitoring, but can be connected to the power supply by a pass-through molex, so you won’t lose a connector. It us not attached by screws, but by some sort of longer pushpins, which are very easy to use.
But that’s not all; you can place 2 more 80 mm fans in the rear panel. Or one 120 mm fan.


Top 80 mm fan:




On the images you already spotted some plexi. What's that? Aha, carry on, to the next page.