Como você pode projetar um circuito de carregamento de bateria para evitar sobrecarga?

Voltage detection circuitry is key to preventing battery overcharging. This circuit controls the charging process by monitoring the battery voltage. When the battery voltage reaches a certain value, the circuit will automatically cut off the charging power to avoid overcharging of the battery. This circuit design allows for simplicity and lower cost. For example, the LFP single battery cell voltage range is 2.5V-3.65V. When the cell voltage is detected to reach 3.65V, the charger stops working. The charging cut-off voltage of 8 strings of 24VLFP batteries is 29.2V, the charging cut-off voltage of 15 strings of 48VLFP batteries is 54.8V, and the charging cut-off voltage of 16 strings of 48VLFP batteries is 58.4V.

DO NOT FOLLOW THE SUGGESTED SOLUTION! The suggested solution fails to mention limiting the current. If you connect a linear regulator to a battery without something to limit the current it could damage the battery. Batteries have specific charging profiles that state the maximum safe current for charging. You must include something to regulate the current. It could be as simple as a series current limiting resistor, but that is not ideal as it will slow charging as the battery gets closer to full.

In addition to the overcharge protection circuit, we can also take some other measures to prevent the battery from overcharging. For example, you can add a timer to the charger to set a charging time. When the charging time is reached, the charger will automatically stop charging to avoid overcharging problems. In addition, you can also add a fuse to the battery. When the battery voltage exceeds the set threshold, the fuse will automatically disconnect the circuit and stop the battery charging.

The switching regulator must carefully control the current to make certain that it does not damage the battery. Lithium batteries are often charged with constant current, constant voltage profiles that start by regulating the charge current until the voltage reaches the target voltage and then hold the voltage constant until the current drops to the desired end of charge current.

In addition to the voltage detection circuit, the temperature detection circuit is also an important part of preventing battery overcharging. When the battery temperature exceeds a certain range, the circuit will automatically cut off the charging power to avoid battery overheating and damage. This circuit design can protect the safe use of the battery.

Charging time control circuit is another circuit design that effectively prevents battery overcharging. This circuit sets a specific charging time and automatically cuts off the charging power when the set time is reached to avoid long-term overcharging of the battery. This circuit design is suitable for batteries that require long-term charging, such as lithium iron phosphate batteries (LFP).

To extend the life of a Lithium rechargeable battery it is helpful to limit the stress to the battery. This can be done by reducing the charge current and voltage below what the battery is rated. Higher current creates heat that could reduce the life of the battery. Lowering the voltage will avoid overcharging which can also impact battery life.

Having a secondary control unit that can when pre programmed, or pre set divert to a separate storage unit independently, but also that is equal to the current method for simplicity and to handle the incoming load, therefore allowing to simply kick in and take over the excess energy created resulting in less wasted energy and or can potentially power other units on site if infrastructure is in place to do so ect ect.