Subscribe to download
Main Battle Beast - vz.4

Updated version with better front axles and steering.

Fire sequence:
1.Hold 2 for 3 seconds. (Standing up and securing magazines.)
2.Press 3. (Preparing the chamber.)
3.Press 4 two times with a small pause. (SHOOTS THE BOMB,Tilting chamber into firing position, launching and moving it to secure pos.)
4.Press 5. (Pushing the main mag. spring further.)
5.Press 4 two times with a small pause.
6.Press 6. (Pushing the main mag. spring even further.)
7.Press 4 two times with a small pause.
8.Press 7. (Pulling the main mag. spring out.)
9.Press 8 or 9 two times with a small pause. (Loading new bombs from left or right mag.)
10.Use keys for additional magazines springs to deliver the bombs to carriers. (C,V,B and N,M and ,)
11.Press 6 or 5 or J or combination of them to push the main mag. spring. Depends on how many bombs you loaded.
12. Repeat from point 3.

For emptying the magazine in one go you can go make point 1, then press J, then 3 after that press 4 and 7 for barrage. Bombs will find their way out.

In case of torch being put out, press O to reignite.

Springs gets stuck uccasionaly, fiddle with the controls to get them right, this should be only known problem.

List of all keys for troubleshooting and advanced control:

Legs:
Arrows for driving and turning.
R,F rear legs
T,G front legs

Chamber:
Z for launching the water cannon and turning on the piston for chamber stops
H for tilting the chamber. (Never tilt down without water cannon on!)

Main magazine:
U,J and K for moving main mag. spring
I for moving main mag. spring down (Impossible if its still inside mag., actuate retractable spring too)
L for detaching/attaching grabbers
P for actuating retractable springs for main mag. spring pistons (helps not getting main spring stuck)

Left additional magazine:
Y for tilting the carrier
C,V and B for moving the spring

Right additional magazine:
X for tilting the carrier
N,M and , for moving the spring

O for reigniting the torch with flamethrower
1 for camera

Note that i am using QWERTZ and also some region specific symbols so you might have to rebind to correct it.

Thanks for having a look and have a great time! ^^