Two types of welding ✌️✌️
Hello sir how are you I'm electric welder I'm looking for a job
Buongiorno Giorgio and happy new year first of all. About the welds you show on the pic, I was wondering if you had a WPS in your hands to set up the parameters as required (and recommended) or you did it intentionally at will… as an experiment to share here, in order to rise an interesting discussion ?(successfully let me say 😉🤟🏻). Just because travel speed (as V/Amps as well) obviously affects the heat input and the bead dimensions (especially the width) and it was correctly observed by someone on the comments. As well as the selection of the rod diameter and so on… It’s crystal clear your have a good hand and the weaving technique confirms it (just affected by the rod diameter). Thanks and ciao.
right side: small rod diameter, low welding velocity, intensive weaving, high heat input and low effect; bad efficiency. left side: walking the cup, big rod diameter, intensive weaving, lower heat input than left side, welding velocity to high (blue colour). Welders skill left and right ok, but not indoctrinated for this special task. TIPTIG would solve most of welder skill problems
Sempre gostei da esquerda! 😅
Looks like both tig but maybe the right side had a trailing purge
Don’t like welds that I can grate cheese with
Both TIG different style
I am MIG and arc welder 20 year old experience india and gulf
it's not that difficult, but good.
Consultant Welding Technology & Engineering & Quality Assurance
1moBad and worse They are both TIG welds. The one on the right has very tight ripples and the one on the left looks to be weaving very course and cold.